How To Change Satellite Setting On Sky Decoder

Chris5

what does the LNB Reset bill of fare on the SKYHD box actually do?

wallace4793

I have exactly the same outcome with poor quality on signal 1 and sometimes none on input two. I cocky installed sky hd and my alignment is fine as i plugged my old unmarried lnb in and rechecked the forcefulness/quality. Therefore i deduced it is the lnb and accept ordered a new dual ane as ive heard quad arent as good anyway.

colin324

To reset the LNB:

1. Press services on your Heaven remote control.
2. Highlight Organization Setup using the up/downwardly arrows and press select.
three. Press 0, then 1, then select.
4. Printing select again to access the LNB setup screen.
5. Using the up/downwards arrows, highlight LNB Power Supply.
half-dozen. Using the left/correct arrows change the setting to off.
7. Using the upward/down arrows, highlight 22KHz control.
eight. Using left/right arrows change to off.
9. Using the upwardly/downwardly arrows, highlight Save New Settings and press select.
x. Printing sky followed past services.
11. Highlight System Setup and press select.
12. Press 0 and so 1 then select.
13. Press select again to admission the LNB setup screen.
14. Printing the cherry-red button to re-set up the default settings.
fifteen. Using the upwardly/downwardly arrows, highlight Save New Settings and press select.
xvi. Press select to confirm that the settings have been reset.

The right settings are:
- 9.75 for the low frequency.
- 10.60 for the high frequency.
- The LNB ability supply should ever exist set to on.
- The 22KHz Control should always be set to on.

17. Printing heaven to return to normal viewing. It may take 60 seconds for the pic to appear. If this consequence is affecting the playback of recorded textile, you volition need to make a new recording to check whether this procedure has resolved the issue.

Jim Robson · Apr 11, 2009

How practice I do this with the new EPG every bit only 'Sky+ SetUp' (rather than 'SetUp' on its ain) seems to be there? I'k probably missing something pretty obvious but it seems to be unlike with the new EPG.

Give thanks you.

Regards

JimmyR

Thank you to Bones1958 for the information below. I institute this on some other thread.

"Anyway, the guy on the phone took me into the Installers Setup card. To access it the sequence for an Hd Box with new EPG is :

Press Services
Press 001
Then printing Select.

Hope this helps and if anyone can propose a cure to my Heaven box issues (seems unlikely from reading other posts) please suggest."

MartinPickering

I'thousand calculation to this thread because I feel it's misleading.

An LNB itself can not be "reset". It'southward not a figurer and there's nothing inside it that can be "reset". Withal, what you CAN do is put the LNB settings back to factory defaults and that needs merely a couple of push presses in the LNB menu.

In that location'southward more info. here:
How to reset the LNB?